Cartridge Pleat Drapes

Step 1: Measure the Length - Drop

If using rings, measure from the bottom of the ring.

If using a track, measure from the bottom of the glider.

If hanging directly from a rod, measure from the top of the rod.

Then measure down to where you want your drapes to end:

• For window sill length: Measure down to the windowsill and subtract 0.4 inches for clearance.
• For apron length: Measure about 6-8 inches below the sill.
• For floor-length: Measure down to the floor and subtract 0.4 inches to prevent dragging.
• For full wall coverage: Measure from just below the ceiling down to the floor. Subtract 0.4 inches for a clean finish.

If the rod or track isn’t installed yet, estimate about 6 inches above the window frame, or higher if you want full wall coverage.

Step 2: Measure the Width of Your Window

Measure the width of your window recess and add 6-8 inches on each side. This gives the drapes space to stack neatly without blocking the light.

Step 3: Measure Your Curtain Pole or Track

• For a track: Measure the full length from one end to the other.
• For a pole: Measure between the two finials.

Cartridge pleats require added fullness. Multiply your track or pole width by 2 to 2.5 to achieve the best structured look.

Step 4: Double-Check Your Measurements

Review your measurements before placing your order. Correct sizing ensures your cartridge pleat drapes hang neatly and create a polished, refined finish.