Pencil Pleat Drapes

Step 1: Measure the Length - Drop

• If using rings, measure from the bottom of the ring.
• If using a track system, measure from the bottom of the glider.
• If hanging directly from a rod, measure from the top of the rod.

Then measure down to where you want your drapes to end:

• For window sill length, measure down to the windowsill and subtract 0.4 inches for clearance.
• For apron length, measure about 4-6 inches below the sill.
• For floor-length, measure down to the floor and subtract 0.4 inches to prevent dragging.
• For full wall coverage, measure from just below the ceiling down to the floor. Subtract 0.4 inches for a clean finish.
• If the rod or track isn’t installed yet, estimate about 6 inches above the window frame as a guide, or higher if you want full wall coverage.

Step 2: Measure the Width of Your Window

Measure the width of your window recess and add 6-8 inches on each side. This allows the drapes to stack neatly when open without blocking the light.

Step 3: Measure Your Curtain Pole or Track

• For a track: Measure the full length from one end to the other.
• For a pole: Measure between the two finials.

Multiply your track or pole width by 2 to 2.5 to get the right amount of fabric for a rich, full pleated look.

Step 4: Double-Check Your Measurements

Review your measurements carefully before ordering. Accurate sizing ensures your pencil pleat drapes hang neatly and create the structured, elegant finish you’re looking for.