Tab and Tie Top Drapes

Step 1: Measure the Length - Drop

• Measure from the very top of the rod to where you want your drapes to end.
• For window sill length, measure down to the windowsill and subtract 0.4 inches for clearance.
• For apron length, measure about 4–6 inches below the sill.
• For floor-length, measure down to the floor and subtract 0.4 inches to prevent dragging.
• For full wall coverage, measure from just below the ceiling down to the floor. Subtract 0.4 inches for a clean finish.
• If the rod isn’t installed yet, you can estimate about 6 inches above the window frame, or higher if you want full wall coverage.

Step 2: Measure the Width of Your Window

Measure the width of your window recess and add 6–8 inches on each side. This ensures the drapes fully cover the window and stack neatly when open.

Step 3: Measure Your Curtain Rod

Measure the full width of the rod, not including any decorative finials at the ends. Plan to use about 1.5 to 2 times the rod width in fabric for a nicely gathered, full look.

Step 4: Double-Check Your Measurements

Double-check all measurements before placing your order. Accurate sizing ensures your tab and tie top drapes hang beautifully and fit your space perfectly.